What is to be done when a new inverter installed replacing the old inverter?

!When there is an inverter swapped in the compressor, all the data and logbook is left in the old inverter as well as the whole programming. The compressor will not be running with the new inverter because all the programming and particular setup for this particular compressor is not present in the new inverter.

The old inverter controller card ( the PCB where all the control cables, like pressure sensor, temperature probe, bluetooth connected) must be swapped from the old inverter and installed to the new one before attempting to run the compressor. When control card is swapped, compressor must be connected to the app so does the U.S. Air compressor servers before it runs.

• The serial number ,
• The service hours left to service ,
• Pressure ,
• Temperature ,
• PSET
  must be seen on the app to verify if the swapped controller card correctly connected or performing right.